HB Body 222 Bumpersoft Car Body Filler Black Putty For Plastic Bumpers 250g With Hardener Excellent Adhesion Easy To Sand With P120-P240

Product Information

After 5 minutes shape tab using 3M™ Cubitron™ II Roloc™ Fibre Disc 80+ / 180+ and create a new fixing point to restore original appearance. Apply activator (if applicable). If you are using an activator, apply it to both surfaces unless otherwise indicated. Wait until it has dried completely, then proceed with the adhesive.

Clean the area inside and outside using 3M™ VHB™ Surface Cleaner or 3M™ General purpose Adhesive Cleaner applied with a 3M™ Professional Panel Wipe. Rigid PVC strips are manufactured from a different material to our flexible plastic strips and we encourage you to request samples if you are unsure which material to choose. Also, curing epoxies are hydroscopic so the low temperature environment may well leave the resin vulnerable to absorbing moisture, especially if the environment is relatively damp or high in humidity as can be found in some outdoor workshops or home garages. To finish the repair and prepare for the primer, the use of a Plastic Filler Product is recommended. You are very welcome to request samples of PVC strip if you are unsure about exactly which plastic flat strip you need. You may wish to see the colour, the different type of material, the width or the edge style.Immediately fold the sheet and shape adhesive with fingers. Force adhesive into the drilled holes. Do not press too hard to keep a 3 to 5 mm layer of adhesive material on both side of the tab. What is the best way to ensure that a plastic bumper tab, which was rebuilt with 3M™ Super Fast Repair Adhesive, will reliably adhere to a bumper surface? Once hardened, finish the sanding with wet fine grit sandpaper for a really smooth finish and wipe away any dust. To finish the plastic bumper repair and prepare for the primer, the use of a plastic filler product is recommended. Use either 3M™ Flexible Plastic Filler for plastic-like performance and excellent sanding and feather-edging, or use 3M™ Plastic Filler.

Depending on the nature of your project you need to consider the width of the plastic flat strip that you need. The smallest width of plastic (PVC) flat bar strips range is 6mm and the widest is 142mm.Epoxy resins have very little odour and so it's quite viable to use them indoors (i.e. in your house) without upsetting anyone. The resin is almost completely odourless and the hardener has an amonia smell which doesn't really carry or linger. Thoroughly clean the bumper inside and out. Any dirt or grease will stop the filler bonding properly and ruin the appearance of the repair. Allow to dry and wipe down with solvent wipes, which are usually included in the kit. product/helpAdviseTab.hbs -->

Gather materials. Get together all the plastic pieces you want to join. You’ll also need and your adhesive, of course, tissue paper, something to protect your work area, and sandpaper (for bonding smooth surfaces).Apply a liberal amount of repair material to the damaged area so that you make the surface a little higher than surrounding bumper. Use a spreader like a squeegee to carefully smooth out the filler. Make sure to push the filler into any scratches to fill them right to the bottom. Cover with smoothing film if supplied and allow to dry and fully harden. Using a 3M™ Cubitron™ II Clean Sanding Abrasive Disc 180+, sand the area to shape, ready for either an application of plastic filler or prepare directly for primer application. Remove the masking tape and sand down the damage at the front to make the area a little low and create a rough surface for bonding. Apply bonding liquid if supplied.